Click To Call(904) 747-6756Click To Get A Free Estimate
Front driveway of gray pavers at a Nocatee house with one cleaned stripe beside an old faded section

Faded, sandy pavers can look new again

Paver Restoration and Resealing in Nocatee, FL

Call (904) 747-6756 for a free estimate to restore and reseal tired pavers at your Nocatee home.

  • Brings out deeper paver color
  • Fresh joint sand helps lock pavers in place
  • Gives weeds less room to grow
  • Makes the surface easier to keep clean
  • Free estimate, no obligation

Request a Free Estimate

Free, no obligation.

Step 1 of 2

Where are your pavers?

Please choose one.

Free EstimateNo obligation
Fast ReplyWithin 1 business day, usually much sooner
Typical Local Price$1.75 to $3.25 a sq ft to clean, sand and seal
Call Now(904) 747-6756
Paver restoration

Can Nocatee pavers be restored, and who handles it?

A local contractor restores and reseals pavers across Nocatee, and a response to your request arrives inside one business day, frequently within hours. The visit and the written price cost nothing, and saying no is fine. To start with a call, dial (904) 747-6756.

Restoration is for pavers that have been through several summers: color gone flat, joints sitting low, a patchy old coat and a few stains. The work cleans the surface, refills the joints, fixes small problems and puts down a fresh coat so the area looks cared for again. If a paver wobbles or a spot holds water, the contractor tells you before pricing the finish. Describe what bothers you most when you request your free estimate.

Call (904) 747-6756

What does paver wear look like in Nocatee, step by step?

HydroSeal, a Jacksonville resealing company, says Nocatee's open sun, irrigation, summer rain and daily traffic fade color and lower joint sand, even on newer installs. It describes wear in a rough order: flat color first, then low joints, then staining, then uneven coating wear. The order matters because the later stages decide whether the old coat can stay. For a read on which stage your pavers are in, call (904) 747-6756.

Big front driveways make every stage easy to see from the street. A single dull strip where the tires run, or a pale patch near a sprinkler, stands out against the rest of the surface. Nocatee broke ground in 2005 and grew from 4,524 people in 2010 to 22,503 in 2020, so plenty of pavers there are now old enough to show it. Walk the contractor along the worst edges when you request your free estimate.

Two contractors working a driveway, one with a rotary cleaner and one sweeping sand into the joints

When is sealer too far gone to seal over?

A coat that has turned white, cloudy or begun to peel is done. HydroSeal says it will not seal over whitening, peeling or trapped moisture, or over a coating it cannot identify, and that matching the new sealer to what is on the surface prevents most failures. A Nocatee company that posts rates lists a stripping and full restoration price for exactly this case. Take a close photo of the cloudy area and call (904) 747-6756.

Fresh pavers are the opposite case. Unilock says to hold off on sealing until the white haze of efflorescence has cleared, and that can take 2 to 3 months or up to a year. A haze on a new driveway is not a failed coat, and stripping it would be a waste. Ask the contractor to tell the two apart when you request your free estimate.

How it works

What is the paver restoration process, in order?

The steps run in a set order, and skipping one shows up later. A Nocatee company lists them as inspect and protect, a three step clean matched to the surface, repairs and joint sand, a dry check and then two coats of sealer. HydroSeal gives a shorter version: inspect, deep clean, restore low joints, apply a compatible sealer. To hear how a contractor would handle your surface, call (904) 747-6756.

1. Inspect

Old coating, stains, efflorescence, washed out joints, settling and root damage are noted before anything is covered or wet.

2. Clean or strip

A matched cleaner takes off growth and buildup. Failed sealer, if any, is stripped.

3. Repair and re-sand

Sunken sections are rebuilt, loose pavers reset, and kiln dried sand is swept into every joint.

4. Dry check

The surface and joints must be dry. Hazing is blamed on sealing damp pavers, per a Nocatee company.

5. Seal

Two coats go on at the label rate. About 24 hours for feet and 48 for vehicles is typical.

6. Walk through

The contractor shows you the finish and tells you how long to keep sprinklers off.

Do I need repairs before my Nocatee pavers are resealed?

Sometimes, and it is better to know up front. A Jacksonville repair company lists base erosion, poor compaction, leaking irrigation, burrowing animals, rotting or growing roots, heavy vehicles and failed edge restraints as the causes of sinking, washout and spreading. Its repair order is to find the cause, rebuild the base, fix the edging and then reset the pavers. Another company adds that cracked pavers can be swapped out and matched to the pattern. To have a dip or a rocking paver looked at, call (904) 747-6756.

Joint sand is the repair almost every driveway needs. A company that serves Nocatee says worn sand lets pavers move and weeds in, and a First Coast washing company says builder joints often fail within two or three summers. Plan on fresh sand as part of any restoration, and ask about it when you request your free estimate.

How do Nocatee summer storms and sprinklers wear on a reseal?

Water does most of the damage. Safe Touch, a First Coast washing company, says summer storms pull sand out of driveway aprons and pool decks, and irrigation marks show up as orange stains on concrete within a year or two of closing. HydroSeal adds that irrigation can mineral stain along drainage paths. The Crosswater at Nocatee manual makes JEA reuse water the only irrigation source in that village. Point out every sprinkler head when you request your free estimate.

How long does a restoration take, and when can I use the driveway?

A company that serves Nocatee says most jobs take one to two days. It puts foot traffic back after about 24 hours and cars after about 48, and a First Coast washing company calls sand and seal on empty joints a two day job. Unilock asks for 24 to 48 hours of clear weather and says to keep sprinklers off while the coat cures. Ask the contractor to watch the forecast with you when you request your free estimate.

Pricing

What should paver restoration cost in Nocatee?

No page lists one restoration price, so use the pieces. Stripping old sealer and fully restoring is posted at $2.75 to $3.50 per square foot by one Nocatee company, which puts an 800 square foot driveway near $2,200 to $2,800. If the coat is still sound, clean, sand and seal runs $1.75 to $2.50 there and $1.75 to $3.25 across the First Coast. For a price on your pavers, request your free estimate.

Repairs sit on top. Fixes start at $175, and leveling or re-basing is posted at about $8 to $20 per square foot, so a 50 square foot dip lands near $400 to $1,000. A quote far under these numbers deserves a question about what was left out. To check a bid you already have, call (904) 747-6756.

Compare with the paver sealing guide, the cleaning and joint sand page and the stain removal page.

Restoration stepPublished priceOn an 800 sq ft driveway
Clean and fresh joint sand$0.75 to $1.00 per sq ft$600 to $800
Clean, sand and seal$1.75 to $2.50 per sq ft$1,400 to $2,000
Clean, sand and seal, First Coast range$1.75 to $3.25 per sq ft$1,400 to $2,600
Strip old sealer and fully restore$2.75 to $3.50 per sq ft$2,200 to $2,800
Paver repairsFrom $175Priced by the job
Leveling and re-basing a sunken spotAbout $8 to $20 per sq ft$400 to $1,000 for a 50 sq ft dip

Rates are published by two companies that serve Nocatee, read in November 2026. Neither page lists a single restoration price, so the table shows the separate pieces a restoration is built from. Your contractor sets the real number after seeing the pavers.

Get a Free Estimate

Sunny Nocatee screened pool lanai with tan pavers that have been cleaned and resealed

Which towns near Nocatee can get paver restoration?

Restoration requests come from Nocatee and from every town below, and each name opens a page about that place. The list reaches about 20 miles out from Nocatee. If yours is missing, call (904) 747-6756.

Photos

What do restored pavers look like in Nocatee?

Freshly sealed travertine look paver driveway with the homeowners waving on a restored Nocatee driveway
Sealed paver pool deck on a restored Nocatee driveway
Sealed paver lanai with an outdoor kitchen beside a screened pool on a restored Nocatee driveway
Sealed paver walkway with lantern lights to a front porch on a restored Nocatee driveway
Close view of freshly sealed pavers on a restored Nocatee driveway
Paver area with one cleaned half beside a dirty half on a restored Nocatee driveway
Contractor cleaning pavers on a restored Nocatee driveway
Contractor sealing or sanding pavers on a restored Nocatee driveway
Questions

Frequently Asked Questions

How much does paver restoration cost in Nocatee?

A company that serves Nocatee posts $2.75 to $3.50 per square foot to strip old sealer and fully restore, which puts an 800 square foot driveway near $2,200 to $2,800. If the old coat is still sound, a plain clean, sand and seal runs $1.75 to $2.50 at that company. Sunken spots are priced separately.

Is paver repair different from paver restoration?

Yes. Repair fixes the structure: base erosion, sunken sections, broken pavers and failed edging. Restoration brings back the surface with a deep clean, new joint sand and a fresh coat. A Jacksonville repair company says the cause comes first and the base is rebuilt before pavers are reset.

How much should I pay for paver sealing?

Published First Coast prices for a full clean, sand and seal run $1.75 to $3.25 per square foot. If your old coating has failed and has to be stripped first, the price moves toward the $2.75 to $3.50 that one Nocatee company posts for stripping and restoration.

Why is paver sealing so expensive?

The labor sits in the prep. Washing, drying, joint sand and two coats all take time, and a Nocatee company says to check the pavers are dry because sealing a damp surface causes hazing. Stripping failed sealer adds a whole extra stage.

What causes pavers to sink or wash out?

A Jacksonville paver repair company lists base erosion, poor compaction, drainage problems, leaking irrigation, burrowing animals, rotted or growing roots, heavy vehicles and failed edge restraints. Sealer cannot lift any of those, so the cause is handled before pavers are reset.

Can old sealer that has turned cloudy be sealed over?

Not safely. HydroSeal, a Jacksonville resealing company, says it checks the old coating first and will not coat over sealer that is whitening, peeling or trapping moisture, or over a product it cannot identify. The old coat is stripped, the pavers dry, and a compatible sealer goes down.

How long does a paver restoration take?

A Nocatee company says most sand and seal jobs take one to two days, with foot traffic back after about 24 hours and vehicles after about 48. Stripping and repairs add time, and rain can push the schedule.

Should new pavers be restored or left alone?

Newer pavers often need only a look. Unilock says sealing should wait until the white haze called efflorescence is gone, which takes 2 to 3 months and sometimes up to a year. Restoration makes more sense once color has gone flat and joints have dropped.

Want tired Nocatee pavers looking new again?

Send the form or call, and a contractor answers inside one business day, often the same morning.

Call (904) 747-6756

Free, no obligation